Control Systems Lab

Interactive PID tuning simulator

SIMULATION ONLINE
Setpoint
1.00
Process value
0.00
Controller output
0%
SetpointProcess valueController outputError

What Each PID Term Does

The PID controller combines three different responses to error. Their sum becomes the control command sent to the process.

Proportional — P

Kp · e(t)

Responds immediately to current error. Higher Kp usually makes the response faster, but too much can increase overshoot and oscillation.

Integral — I

Ki · ∫e(t)

Accumulates error over time. It helps remove steady-state offset, but excessive integral action can cause windup and slow oscillation.

Derivative — D

Kd · de/dt

Responds to the rate of error change. It adds damping, but is sensitive to noisy measurements.

u(t) = Kp · e(t) + Ki · ∫e(t)dt + Kd · de(t)/dt

Typical Tuning Effects

Exact behavior depends on the process, but these qualitative tendencies are useful for learning PID tuning.

Increase Kp

FASTER

Usually reduces rise time and error, but too much can increase overshoot or instability.

Increase Ki

ZERO OFFSET

Improves steady-state accuracy, but can increase overshoot and settling time.

Increase Kd

DAMPING

Can reduce overshoot and improve settling while increasing noise sensitivity.

Too Little Gain

SLOW

The process reacts slowly and may remain far from the target.

Too Much Gain

OSCILLATE

The process may repeatedly cross the setpoint or become unstable.

Balanced Tuning

SETTLE

A useful compromise keeps speed, overshoot, settling, and actuator effort under control.

Disturbance Rejection

A well-tuned controller should follow a target and recover when an external disturbance pushes the process away from it.
01

Stable Operation

The process value is close to the target.

02

Disturbance

An external load changes the process state.

03

Error Appears

The controller detects the setpoint difference.

04

PID Responds

P, I, and D generate corrective action.

05

Process Recovers

The actuator drives the system toward target.

06

Settling

The loop returns to stable operation.

Closed-Loop PID Concept Map

A PID controller continuously compares the desired value with measured feedback and adjusts the control output.
A

Setpoint

The desired target value.

B

Error

Setpoint minus measured process value.

C

PID Controller

Combines P, I, and D action.

D

Actuator

The controller output drives the process.

E

Plant

The system responds according to its dynamics.

F

Feedback

The measured value returns to the controller.